Support for Glacier falls (GCF) - RST driver Injection in WinPE image: CHKDSK tool reports an error after WinPE is loaded on the Intel Optane Memory volume and 17.x RST Driver is not injected to WinRE image.Intel RST driver17.0 or later is required to be injected in WinPE image.
![]() Intel Rapid Storage Technology Not Running Driver Is NotIt is recommended not to load WinPE image if Intel Optane Memory H10 is already paired and if RST driver 17.0 or later is not loaded in WinPE image. Intel Rapid Storage Technology Not Running Update Starting WithSecurity update starting with RST 17.5.1.1021: Intel RST 17.5.1.1021 and later has been updated to include functional and security updates. Configuration Impacted: Intel Optane Memory volume 32 GB and higher. Intel Optane Memory Pinning service: Intel Optane Memorys pinning service crash intermittently post Optane enabling, if there is a power OnOff event during Optane enablement. Workaround Disable and enable Intel Optane Memory to reset the pinning service. Enabling Intel Optane memory with H10 (Teton glacier) SSD recommendation Intel Optane Memory H10 must be enabled in AC mode. In addition, good practice is to match the Intel RST driver version in Windows PE manufacturing and the shipping image. Intel Optane memory volume roaming: Intel Optane memory volume when moved from Intel RST Premium with Intel Optane System Acceleration (RAID Mode) to AHCInonOptane mode configuration and switched back to Intel RST Premium with Intel Optane System Acceleration (RAID Mode) can make the drive non-bootable. RTD3: If RTD3 is enabled, Windows can turn off disk for very short time (e.g. The minimum off time for some disks can be much longer (even 1s). If the disk is turned on too fast, it can hang in some undefined state. RTD3 should be disabled if the disk specification states longer minimum off time. INTEL RST UIInstaller: This method is targeted for experienced users who want to have control of the configuration process are recommended to use this method. Obtain the Intel RST SWdriver installation package and run the executable (SetupRST.exe) 2. Install the defaults and reboot the computer 3. From Windows desktop, find and launch the Intel RST UI application. The application will open to the Status page 5. Click the Enable link to start the enabling process. A pop-up will prompt you to Select a compatible fast drive (the Intel Optane NVMe device) 8. Depending on the size of your Intel Optane memory module, a progress bar may be displayed 10. System reboots into Windows to complete the enabling process. And thats not all you should expect: updating the RST version can also bring about improved storage performance, lower power consumption, faster boot times, quicker data reads, as well as several other changes. As far as applying this release is concerned, simply make sure your system configuration is compatible with this package, run the available setup, and follow the on-screen instructions for a complete installation. In addition to that, dont forget to perform a reboot to make sure that all changes take effect properly. Even though other operating systems might be compatible as well, we do not recommend installing this package on platforms other than the specified ones. With this in mind, click the download button, and get and apply the present version. Also, check with our website as often as possible in order to stay up to date with latest releases. It is highly recommended to always use the most recent driver version available. Try to set a system restore point before installing a device driver. This will help if you installed an incorrect or mismatched driver. Problems can arise when your hardware device is too old or not supported any longer. Softpedia and the Softpedia logo are registered trademarks of SoftNews NET SRL Contact.
0 Comments
Leave a Reply. |